Exterior Inspection Section#2 Exterior Cladding Test#2

• Question 1

  1 out of 1 points

  	What is an example of a capillary break on the exterior of the building?
  	Selected Answer: a.  the part of a sill that prevents water from running along the underside back to the wall Answers: a.  the part of a sill that prevents water from running along the underside back to the wall b.  the mortar joint between bricks that deflects heavy winds c.  the flashing at the bottom of a stucco wall that deflects water away from the edge d.  the holes at the bottom of a masonry veneer wall that allow water to drain e.  the flashing above a window that prevents leakage from water running down the wall

• Question 2

  1 out of 1 points

  	What causes brick to spall?
  	Selected Answer: b.  water saturation and freezing temperatures Answers: a.  water saturation and very hot weather b.  water saturation and freezing temperatures c.  heavy rain d.  dry weather e.  high winds

• Question 3

  1 out of 1 points

  	A large number of patched holes in a uniform pattern on an exterior most likely indicates what?
  	Selected Answer: b.  insulation installation Answers: a.  mechanical damage b.  insulation installation c.  vermin activity d.  weather damage e.  water leakage

• Question 4

  1 out of 1 points

  	The main purpose of soffits and fascia is to
  	Selected Answer: d.  enclose rafter ends at the roof overhang Answers: a.  protect windows and doors below b.  provide cosmetic detail c.  protect wall surfaces below d.  enclose rafter ends at the roof overhang e.  support roofing materials

• Question 5

  1 out of 1 points

  	How thick should a three-layer stucco application be?
  	Selected Answer: d.  7/8 inch Answers: a.  1/8 inch b.  1/4 inch c.  3/8 inch d.  7/8 inch e.  1 1/4 inches

• Question 6

  1 out of 1 points

  	Compared to regular lumber, OSB is more prone to what?
  	Selected Answer: a.  swelling Answers: a.  swelling b.  rot c.  cracking d.  warping e.  paint/stain problems

• Question 7

  1 out of 1 points

  	What is the major risk if a foundation wall does not extend above grade?
  	Selected Answer: b.  water damage to wood structure of house Answers: a.  wind penetration through the siding b.  water damage to wood structure of house c.  excess stud length on the first floor walls d.  damage to interior furnishings e.  poor support for masonry

• Question 8

  1 out of 1 points

  	Aluminum flashings on stucco walls are particularly vulnerable to
  	Selected Answer: d.  corrosion Answers: a.  warping b.  mechanical damage c.  splitting d.  corrosion e.  sagging

• Question 9

  1 out of 1 points

  	Battens typically overlap each siding board by how much, expressed in inches?
  	Selected Answer: c.  1/2 Answers: a.  1/8 b.  1/4 c.  1/2 d.  3/4 e.  1

• Question 10

  1 out of 1 points

  	All of the following types of caulking materials are paintable EXCEPT
  	Selected Answer: b.  silicone Answers: a.  silicone latex b.  silicone c.  latex d.  acrylic latex e.  polyurethane

• Question 11

  1 out of 1 points

  	All of the following statements about masonry walls are true EXCEPT they
  	Selected Answer: d.  are impervious to water Answers: a.  may or may not be load bearing b.  typically require a foundation c.  should not usually be installed at or below grade d.  are impervious to water e.  may be damaged by attempts at cleaning

• Question 12

  1 out of 1 points

  	Coping is a
  	Selected Answer: a.  parapet wall covering Answers: a.  parapet wall covering b.  metal siding fastener c.  vinyl siding fastener d.  window flashing e.  window covering

• Question 13

  1 out of 1 points

  	What best describes chalking? It is
  	Selected Answer: a.  the deterioration of paint due to ultraviolet radiation Answers: a.  the deterioration of paint due to ultraviolet radiation b.  the dry rot of wood c.  the mineral deposits left on masonry walls due to rising damp d.  the deterioration of masonry walls due to rising damp e.  the corrosion of copper fasteners

• Question 14

  1 out of 1 points

  	Horizontal cracks above windows in masonry walls are usually caused by
  	Selected Answer: c.  rusting lintels Answers: a.  differential building settlement b.  frost heaving c.  rusting lintels d.  hydrostatic pressure e.  mechanical damage

• Question 15

  1 out of 1 points

  	Which of the following statements about weep holes in masonry walls is true? They
  	Selected Answer: a.  allow water to drain out from behind masonry veneer Answers: a.  allow water to drain out from behind masonry veneer b.  allow water to drain to the interior of the house c.  are found above windows in solid masonry walls d.  are found below the eaves e.  are found at corners

• Question 16

  1 out of 1 points

  	A bowing masonry wall is most likely caused by
  	Selected Answer: b.  failed masonry ties Answers: a.  racking of the wood framing b.  failed masonry ties c.  mechanical damage d.  building settlement e.  heavy furniture inside the house

• Question 17

  1 out of 1 points

  	Heavy siding like brick and stone are typically supported from below by
  	Selected Answer: c.  foundations and footings Answers: a.  masonry ties b.  headers c.  foundations and footings d.  sill plates e.  joists

• Question 18

  1 out of 1 points

  	Which of the following wood siding corner details is considered to be the LEAST desirable?
  	Selected Answer: a.  mitered Answers: a.  mitered b.  outside corner board c.  inside corner board d.  metal outside corner e.  inside corner post

• Question 19

  1 out of 1 points

  	Strips of vinyl siding typically overlap vertically by how much?
  	Selected Answer: b.  1/2 to 1 inch Answers: a.  1/4 to 1/2 inch b.  1/2 to 1 inch c.  1 to 1 1/2 inches d.  1 1/2 to 2 inches e.  2 to 2 1/2 inches

• Question 20

  1 out of 1 points

  	All of the following are common types of mortar joints EXCEPT
  	Selected Answer: b.  u-joint Answers: a.  concave joint b.  u-joint c.  v-joint d.  raked joint e.  extruded joint

• Question 21

  1 out of 1 points

  	Common soffit problems include all of the following EXCEPT
  	Selected Answer: a.  oversized soffit Answers: a.  oversized soffit b.  loose or missing soffit pieces c.  rotten soffit d.  damaged soffit e.  paint/stain needed

• Question 22

  1 out of 1 points

  	When repointing a masonry wall, the old mortar should be raked out to what depth before applying the new mortar?
  	Selected Answer: c.  3/4 inch Answers: a.  1/4 inch b.  1/2 inch c.  3/4 inch d.  1 inch e.  1 1/4 inches

• Question 23

  1 out of 1 points

  	All of the following are common siding materials EXCEPT
  	Selected Answer: a.  Tyvek Answers: a.  Tyvek b.  stucco c.  plywood d.  vinyl e.  concrete block

• Question 24

  1 out of 1 points

  	Common window and door problems include all of the following EXCEPT
  	Selected Answer: e.  missing Answers: a.  encroaching vine growth b.  mechanical damage c.  putty problems d.  frame deformation e.  missing

• Question 25

  1 out of 1 points

  	Exterior cladding is intended to do all of the following EXCEPT
  	Selected Answer: d.  provide a vapor barrier Answers: a.  protect the structure from water damage b.  protect the interior from water damage c.  provide reasonable security d.  provide a vapor barrier e.  enhance the appearance of the home